1/2" x 2AS Series Timber Wolf® band saw blade

(7 reviews) Write a Review
1.00 LBS
Calculated at Checkout
Adding to cart… The item has been added
Timber Wolf® 1/2" x 2AS

Blade Designation: Roughing or Milling Green Wood/Logs

Width: 1/2"
TPI (Tooth Per Inch): 2
Blade Thickness: .032
Kerf: .056
Tooth Hook Angle: 6.5°
Tooth Set Pattern: AS (alternate set)
Radius of Cut: 2 1/2”

Thickness of Work Material to be cut
Kiln Dry Wood: Hardwood 6" - 15" Softwood 6" - 15”
Green Wood: Hardwood 6" - 15" Softwood 6" - 15”

7 Reviews Hide Reviews Show Reviews

  • 2
    blade broke

    Posted by Dan on Nov 27th 2022

    Blade broke with less than 4 hours of usage, not under load. Not sure why.

  • 5
    exellent bandsaw blade

    Posted by Michael Tompkins on Oct 17th 2022

    these blade just go and go, and I make them work hard.

  • 5
    Excellent blade!

    Posted by Robert Derosier on May 3rd 2021

    I mill logs on my 15 inch 3 hp Jet bandsaw, and this is the best blade I've used so far. Cuts right through 13-14 inch oak. The key so far is to keep the blade clean and adjust tension according to Timber Wolf instructions. Would buy again and certainly recommend to others.

  • 5
    Excellent blade

    Posted by Jim on May 23rd 2019

    I have a Craftsman 14” band saw and have always used craftsman replacement blades because they were the only ones available in Fairbanks. When Sears closed I found PS Wood Machines and decided to give them a try. I ordered 5 blades and so far have only used the 1/2” blade. Right from the packaging I felt the blade was much more stout. After trying a few cuts on thick burl material I was astonished with the smoothness of the cut. There didn’t seem to be nearly as much flimsiness either. I hope the thinner blades perform as well as the 1/2” blade. Overall I would say this is an excellent quality blade.

  • 5
    excellent blade

    Posted by Robert on Dec 2nd 2018

    Title says it all, excellent quality blade as always from pswood,the only bandsaw blades I use. Very very sharp and holds it's edge well, resaws green 6-10" oak with ease.

  • 5

    Posted by Roger Anderson on May 24th 2018

    This is only my third Timber Wolf blade. The first was a 3/4 3 tpi which being a novice, I abused the hell out of using it in wet wood. I've resharpened that one twice (with a tapered diamond file that fits the gullet) now with very good results. I've heard of bandsaw blades breaking if not handled properly during the cut....this one took a beating and kept on ticking. As to the 1/2 3-tpi AS, I'm taking a face cut off some 6 x 12 reclaimed timbers and it has been spot on. I did adjust the wheel so the BACK of the blade centers in the cut....so there is no drift and I was much more careful to keep the feed speed reasonable. I have tried a couple blades from different companies....and think I will stick with Timber Wolf after this, they seem like very high quality, given my limited experience. Veteran '66-68

  • 5
    Must Have Blade

    Posted by Jerry on May 23rd 2018

    If you are going to process some green wood into spindle & bowl blanks this is the blade for you. My saw goes to 8" thick and the blade does an excellent job. Also, PS Wood stands by their weld breakage warranty. I broke a blade recently and they replaced the blade.